BLADE WING
The Core Piece
Made of a ballistic Cordura material, the outer shell provides maximum abrasion resistance and yet is flexible enough to streamline and fit firmly around the diver. The inner bladder is made of rugged nylon and thus offers additional protection against damage. The fittings for the inflator and the dump valve are ultrasonically welded to the bladder making them highly robust. European high-tech manufacturing.
Overall, the BLADE wing has three inflator / dump valves connection points. The inflator can be mounted either on the left or right side of the wing. The connection point at the top is for a dump valve that runs over the shoulder. This offers maximum ease of buoyancy and safety.
In technical diving, the upper connection can be closed with an extremely stable blank plug. The blank plug is included in delivery.
In total, the BLADE has 5 Bungee Attachment Loops (three in the upper and two in the lower area). Optimal positioning is thus always guaranteed. On the inside is the attachment strap, where the wing can be attached to the harness. Moving the wing up or down is done within a matter of seconds.
Check out the Sidemount systems section for the complete system. This is the wing only.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.