This professional glass engraving kit includes all the essentials you will need for glass engraving plus extras to allow you to experiment further with your 3D effects, depth and shading techniques along with some more of our most popular polishers, stones and burrs to further your skill to a whole new professional level.
Kit contains the following items:
- 5 x Diamond Ball Burrs of the following sizes: 0.8mm, 1.0mm, 1.5mm, 2.0mm, and 3.0mm
- 2 x Diamond Point Burrs of the following sizes: 0.6mm, and 0.8mm
- 1 x Diamond Cylinder Burr 4mm x 12mm (400 grit, very fine)
- 1 x Diamond lens Burr 5mm
- 1 x Diamond Disc Burr 3mm
- 3 x mixed shapes of Diamond FG burrs
- 1 x FG to HP Adaptor (Converts FG burrs with a 1.6mm shank to 2.35mm)
- 2 x Green Silicon Carbide Stone Burr's: Flame and 3mm Ball
- 2 x White Arkansas Stone Burrs: Ball and Cylinder
- 1 x Pack of 16, Mini Rubber Silicone Polishers. 1 of each grade and shape
- 1 x Taper Mandrel (for holding the Bullet and Cylinder shaped silicone polishers)
- 1 x Screw Mandrel (for holding the Wheel and Knife Edge shaped silicone polishers)
- 1 x Bullet, Grey Rubber Silicone Polisher
- 1 x EVEFLEX Brown Rubber Bullet Polishing Burr
- 1 x Pack of 6, Mini Rubber Silicone Pin Polishers, 3mm containing 1 of each grade of polisher
- 1 x 3mm Pin Mandrel (for holding the Pin Polishers)
If you're new to glass engraving and would only like to purchase the essential items needed to get you started then our 'Bare Minimum Glass Engraving Kit' may be better suited.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.