Gripping your inflator or dry suit hose with two fingers, while pulling back on the locking collar with two more fingers on the same hand is difficult if not impossible for some people, using two hands means you need a third to complete the task. XS Scuba's has a QD Adapter that converts any LP hose into an EZQD Hose. Hose adapter eliminates this hassle and allows one handed installation, just place adapter over the end of the QD fitting of your BCD inflator or dry suit valve and push it into place.
Adapter will work on most inflators and dry suit QD's. Once you need to disconnect the hose the large oversized collar makes removal easy even with gloved hands. Adapter is made from marine grade chrome platted brass and will thread onto any standard second-stage end of an LP hose. All O-rings are Viton, so the adapter is oxygen ready out of the package. EZQD has a working pressure of 200 psi (13.8 bars) or below and is easy to install on the end of a low-pressure hose.
Adapter will work on most inflators and dry suit QD's. Once you need to disconnect the hose the large oversized collar makes removal easy even with gloved hands. Adapter is made from marine grade chrome platted brass and will thread onto any standard second-stage end of an LP hose. All O-rings are Viton, so the adapter is oxygen ready out of the package. EZQD has a working pressure of 200 psi (13.8 bars) or below and is easy to install on the end of a low-pressure hose.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
