This kit includes all the essentials you will need for glass engraving plus extras to allow you to experiment further with your 3D effects, depth and shading techniques.
Kit contains the following items:
- 1 x 0.8mm Diamond Ball Burr
- 1 x 2mm Diamond Ball Burr
- 1 x 3mm Diamond Ball Burr
- 1 x 0.6mm Diamond point Burr (Rat's Tail Burr)
- 3 x assorted shapes of Diamond FG burrs
- 1 x FG to HP Adaptor (Converts FG burrs with a 1.6mm shank to 2.35mm)
- 1 x Flame, Green Silicon Carbide Stone Burr
- 1 x 3mm Ball, Green Silicon Carbide Stone Burr
- 1 x 3mm Ball, White Arkansas Stone Burr
- 1 x Pack of 16, Mini Rubber Silicone Polishers. 1 of each grade and shape
- 1 x Taper Mandrel (for holding the Bullet and Cylinder shaped silicone polishers)
- 1 x Screw Mandrel (for holding the Wheel and Knife Edge shaped silicone polishers)
- 1 x Bullet, Grey Rubber Silicone Polisher
- 1 x EVEFLEX Brown Rubber Bullet Polishing Burr
If you're new to glass engraving and would only like to purchase the essential items needed to get you started then our 'Bare Minimum Glass Engraving Kit' may be better suited. If you're already using many of the items in the Experimental kit and would like to expand your skill further why not try our Professional Glass Engraving Kit.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
