Twin sets come complete with your choice of isolation manifold, stainless steel bands with hardware, and self-draining tank boots.
Faber Steel Cylinder Features:
- 5 HP models available: 80, 100, 120, 117, or 133.
- Triple coated gray finish or hot dipped galvanized
- D.O.T and T.C. approved
- Includes self-draining tank boots
Thermo Isolation Manifold - DIN Features:
- DIN - Dedicated 300 bar
- Center-to-center distance: 215 mm (8.46?) +/- 5 mm (0.2?)
- 3/4?-14 NPSM standard inlet threads
- High gas flow for optimum regulator performance
- On/Off seat built from high strength brass with nylon seat and Teflon® plated for years of smooth operation
- One-piece safety assembly protected within the body of the valve
- Traditional copper crush washer sealed bonnet
- Modular access plugs (R/L) included for use as single valves
- Screw-in dip tube with hex tighten feature
- Meets the requirements of CGA V9-2009 standards
Thermo Isolation Manifold - PRO Features:
- PRO - DIN/Yoke with removable spin-out insert
- Center-to-center distance: 215 mm (8.46?) +/- 5 mm (0.2?)
- 3/4?-14 NPSM standard inlet threads
- High gas flow for optimum regulator performance
- On/Off seat built from high strength brass with nylon seat and Teflon® plated for years of smooth operation
- One-piece safety assembly protected within the body of the valve
- Traditional copper crush washer sealed bonnet
- Modular access plugs (R/L) included for use as single valves
- Screw-in dip tube with hex tighten feature
- Meets the requirements of CGA V9-2009 standards
Isolation PRO Manifold Features:
- PRO - DIN/Yoke with removable spin-out insert
- XS Scuba Safety Handwheel - Know at a glance that your valve is 100% open
- 1.5 rotations of the handwheel from fully on to fully off
- Center-to-center distance: 215 mm (8.46?) +/- 5 mm (0.2?)
- 3/4?-14 NPSM standard inlet threads
- On/Off seat built from high strength brass with nylon seat and Teflon® plated for years of smooth operation
- One-piece safety assembly protected within the body of the valve
- O-ring sealed bonnet
- Modular access plugs (R/L) included for use as single valves
- Screw-in dip tube with hex wrench tighten feature
- Meets the requirements of CGA V9-2009 standards
Highland Steel Band Features:
- 304 stainless with all hardware included
- 2.5" wide bands on all sizes of cylinders
Download Manifold Assembly Instructions
Download Assembling Twin Cylinders
*?Both set ups shown with Thermo manifold.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
